It is possible to refer to the easy step-by-step drawing instructions below.
I’ll do my best to take down this helicopter in the way I am aware of. Begin by drawing a design that closely resembles a slice of pizza. It should also include the crust that is on top.
The first step is drawing out the design of the radar dome as well as the main Rotor, which houses propellers and propellers for the helicopter. Make sure it appears tidy and tidy.
The next step is to slow down while you sketch Apache’s shell. The protrusions on the top are the places where the turbochargers of twin are located, so make sure to get them out properly. Once you’re sure you can tell that the frame of the AH 64 is appealing to you then you can proceed to step three.
The next step is to take on the challenge to draw the wings and the pylons that house the hydra as well as Hell rocket launchers. Once you’ve completed this step you are able to move on to the fifth step.
As you can see , your Apache helicopter will appear very realistic after you’ve completed this step. First, sketch the airbags of the turboshaft twin-axle engine and then draw the cylinders for the rocket launcher hydra and the holes. I removed the rocket to avoid the course to become too difficult. After that, design the landing gear only wheels and legs. In the middle of the helicopter’s fuselage and sketch the night vision device and an turret for the sensor gun. Moving down until you are in the area in which you make the drawing of the M23030mm auto cannon. Draw the entire features and contours of the surface like you see in this picture before moving on to step 6.
The next step is to start drawing out the particulars of the hull. This includes the seams, rivet holes as as the hull in which the gunner and the pilot are. Draw in these windows, and then outline the frame frames for the body and draw out the details and surfaces. Who is sitting in which place? The front window is where the pilot sits and the rear part is where the gunner sits.
Nearly done, dear readers! This is where you sketch or draw using the four-blade system. Also, be sure to make sure you take your time, since the base needs to be drawn neatly for precision.
Finally draw the tail end of the helicopter as shown but even though you cannot discern it, there’s an alleged tail rotor right behind the propeller on the top right. Make sure you clean up your draft or sketch so that that you are able to prepare it for serious color.
The final result will be like once you’re finished. You can now enjoy coloring your AH64 Apache by using color shades like the OD color of green.